Simon Says

You all know the game Simon Says, right? The game where you have to copy whatever the “Simon” or leader is doing. Well, this time, it’s all going in the electronics. Two weeks ago, I went to the Maker Faire in San Mateo, CA and did a workshop on one of the Sparkfun™ kits. It was called Simon Says.

Featured image

The Simon Says Kit comes with :

  • 1x ATmega328 – pre-programmed with Simon firmware (this is a hardware not software project)
  • 1x Buzzer
  • Featured image2x 0.1μF Cap
  • 1x 10K Resistor
  • 4x LEDs (blue, yellow, red, green)
  • 2x Slide Switch
  • 4x Battery Clips
  • 2x AA Batteries
  • 1x Button pad
  • 1x Bezel
  • 4x Standoffs and screws
  • 1x Assembly instructions (you will also need a soldering iron and soldering wire for this project)

It took me about 1 hour and 30 minutes to solder the kit. Very fun project, I reckon!

Soldering Wire
Soldering Wire
Featured image
This is the soldering iron.

 

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s